| Model |
IW9167EH-B-STA |
| Software |
● Cisco IOS XE Software Release 17.15.1 or later |
| Supported wireless LAN controllers |
● Cisco Catalyst 9800 Series Wireless Controllers (physical or virtual) |
| 802.11n version 2.0 (and related) capabilities |
● 4x4 MIMO with four spatial streams in one 2.4 GHz radio and two 5 GHz radios |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11n and 802.11a/g |
| ● 20- and 40-MHz channels |
| ● PHY data rates up to 1.5 Gbps (with 40 MHz on both 5 GHz radios and 20 MHz on the 2.4 GHz radio) |
| ● Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) |
| ● 802.11 Dynamic Frequency Selection (DFS) |
| ● Cyclic Shift Diversity (CSD) support |
| 802.11ac |
● 4x4 downlink MU-MIMO with four spatial streams on both 5 GHz radios |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11ac beamforming |
| ● 20, 40, and 80 MHz channels |
| ● PHY data rates up to 3.4 Gbps (dual 4x4:4SS 80 MHz) |
| ● Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) |
| ● 802.11 DFS |
| ● CSD support |
| ● Wi-Fi Protected Access (WPA) 3 support |
| 802.11ax |
● 4x4 uplink/downlink MU-MIMO with four spatial streams in 2.4, 5, and 6 GHz* |
| ● Uplink/downlink OFDMA |
| ● Target Wake Time (TWT) |
| ● BSS coloring |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11ax beamforming |
| ● 20, 40, 80, and 160 MHz channels (IW9167E 5/6 GHz radio, IW9167I, IW9167E-STA and IW9167E-STA2 6 GHz radio) |
| ● 20, 40, 80 channels (5 GHz radio) |
| ● 20 MHz channels (2.4 GHz radio) |
| ● PHY data rates up to 7.8 Gbps (4x4 160 MHz on 6 GHz, 4x4 80 MHz on 5 GHz, and 4x4 20 MHz on 2.4 GHz) |
| ● Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) |
| ● 802.11 DFS |
| ● CSD support |
| ● WPA3 support |
| Antennas |
● 2.4 GHz and BLE: Peak gain 8 dBi, ±45° crosspolarized, directional antennas |
| ● 5 GHz: Peak gain 9 dBi, ±45° cross-polarized, directional antennas |
| ● 6 GHz: Peak gain 10 dBi, ±45° cross-polarized, directional antennas |
| ● GNSS: Average gain -2 dBi, linearly polarized, omnidirectional antenna |
| Interfaces |
● 1x 100M/1000M/2.5G/5G Multigigabit Ethernet (RJ-45)/M12 X-code autosensing PoE+ in (802.3at/bt), UPOE in |
| ● 1x SFP (copper) 100M/1000M/10G Multigigabit Ethernet /M12 X-code OR 1x SFP (fiber) 1G/10G |
| ● Management console port (RJ-45) |
| ● Multicolor system LED |
| ● DC power input (micro-fit/M12 A-code) |
| ● Reset button |
| Note: PG 13.5 glands or M12 adapters shall be used with Ethernet and power interfaces to meet IP67 rating. |
| Note: Catalyst IW9167E-HZ has permanent M25 ports. M12 adapters are not compatible. See Installation Guide for gland requirements. |
| Dimensions (W x L x H) |
● 14.5 x 14.5 x 4.3 in (36.8 x 36.8 x 10.9 cm) |
| Weight |
● 15.5 lb. (7 kg) |
| Input power requirements |
● 802.3at (PoE+), 802.3bt (PoE++), Cisco Universal PoE (Cisco UPOE®) |
| ● DC power source: 24 to 48 VDC (maximum voltage range: 18 to 60 VDC) |
| ● Cisco power AC-DC power adapter, IW-PWRADPT-MFIT4P= |
| ● Cisco power injector, IW-PWRINJ-60RGDMG= |
| Surge |
● DC power input |
| ◦ EN50121-4, ± 2 kV (line-earth) and ± 1 kV (line-line) |
| ◦ AREMA, ± 1 kV (line-earth) and ± 1 kV (line-line) |
| ◦ CISPR35, ± 0.5 kV (line-earth) |
| ● Surge protection to ± 2 kV on Ethernet ports |
| ● Surge protection to ± 1 kV on SFP copper port with shielded cable |
| Environmental |
● Nonoperating (storage) temperature: -40° to +185°F (-40° to +85°C) |
| ● Nonoperating (storage) altitude test: +25˚C (77˚F), 17,000 ft. |
| ● Operating temperature: -40° to +158°F (-40° to +70°C) with solar load and still air. |
| ● Extended operating temperature (DC powered, not applicable to IW9167ESTA and IW9167E STA2): -58° to +167°F (-50° to +75°C) without solar loading, still air, and cold start limited to-40°C |
| ● Operating type test: +85°C for 16 hours |
| ● Operating humidity: 0% to 100% (condensing) |
| ● Operating altitude: 15,000 ft. (4,500 m) |
| ● Wind resistance: Up to 160 mph (257 km/h) sustained winds |
| Environmental ratings |
● EN/IEC 60529 (IP66 and IP67) |
| System memory |
● 2048 MB DRAM |
| ● 1024 MB flash |
| Available conducted transmit power settings (max/min), all antennas active |
2.4 GHz |
5 GHz |
5/6 GHz |
| ● 24 dBm (250 mW) |
● 30 dBm (1 W) |
● 23 dBm (200 mW) |
| ● -4 dBm (0.4 mW) |
● -4 dBm (0.4 mW) |
● -4 dBm (0.4 mW) |
Cisco Catalyst IW9167EH-B-STA khác gì so với phiên bản IW9167EH-ROW-AP trong phương thức triển khai mạng không dây?
Khác với IW9167EH-ROW-AP được thiết kế chủ yếu để cung cấp vùng phủ sóng Wi-Fi cho thiết bị đầu cuối, IW9167EH-B-STA là phiên bản Station (STA), thường được triển khai như một điểm kết nối trong các liên kết không dây Point-to-Point (PtP) hoặc Point-to-Multipoint (PtMP). Điều này giúp mở rộng mạng đến các vị trí khó kéo cáp quang hoặc cáp Ethernet mà vẫn duy trì kết nối tốc độ cao và ổn định.
Hệ thống ăng-ten của Cisco Catalyst IW9167EH-B-STA có ưu điểm gì so với các model sử dụng ăng-ten đa hướng?
IW9167EH-B-STA được tích hợp ăng-ten định hướng phân cực chéo (±45° cross-polarized directional antennas) với độ lợi lên đến 10 dBi trên băng tần 6 GHz. So với các model sử dụng ăng-ten đa hướng, thiết kế này giúp tập trung năng lượng tín hiệu theo một hướng cụ thể, tăng khoảng cách truyền, cải thiện chất lượng liên kết và giảm nhiễu từ các khu vực xung quanh. Đây là lựa chọn phù hợp cho các kết nối đường dài giữa các tòa nhà hoặc khu vực công nghiệp.
Vì sao Cisco Catalyst IW9167EH-B-STA phù hợp cho các ứng dụng cầu nối không dây trong môi trường công nghiệp?
Cisco Catalyst IW9167EH-B-STA kết hợp ăng-ten định hướng độ lợi cao, tốc độ Wi-Fi 6/6E lên đến 7,8 Gbps, cùng khả năng hoạt động trong điều kiện môi trường khắc nghiệt với chuẩn IP66/IP67, dải nhiệt độ mở rộng và khả năng chống xung điện theo các tiêu chuẩn công nghiệp. Nhờ đó, thiết bị có thể xây dựng các liên kết không dây ổn định giữa nhà xưởng, kho bãi, cảng biển hoặc hệ thống giao thông thông minh, giúp giảm chi phí triển khai so với việc kéo cáp trên khoảng cách lớn.